## Thursday, 22 October 2015

### Slack

#### Slack:

• It is difference between the desired arrival times and the actual arrival time for a signal.
• Slack time determines [for a timing path], if the design is working at the desired frequency.
• Positive Slack indicates that the design is meeting the timing and still it can be improved.
• Zero slack means that the design is critically working at the desired frequency.
• Negative slack means , design has not achieved the specified timings at the specified frequency.
• Slack has to be positive always and negative slack indicates a violation in timing.

#### Required time:

The time within which data is required to arrive at some internal node of the design. Designer specify this value by setting constraints.

#### Arrival Time:

The time in which data arrives at the internal node. It incorporates all the net and logic delays in between the reference input point and the destination node.

Setup Slack = Required time - Arrival time
Hold slack = Arrival time - Required time

#### Setup Slack:

Amount of margin by which setup requirements are met.

TCL = Total combinational delay in a pipe-lined stage

TRC = RC delay of interconnects

TC-Q = Clock to output delay

Tarrival = Arrival time (at node)

Tcycle,min = Minimum Achievable clock cycle

To meet the setup requirements the following equation must be satisfied.

Tslack,setup = Tcycle – Tarrival - Tsetup (For all Paths )

Here Tarrival= TCL + TRC + TC-Q

#### Hold Slack:

Amount of margin by which hold time requirements are met.

Tarrival >= Thold

Tarrival – Thold = Thold,slack

Thold,slack = TCL + TRC + TC-Q - Thold

• The Negative value of Hold Slack means signal value propagates from one register to next, too fast that it overrides the old value before that can be detected by the corresponding active clock edge.
• The Clock frequency variation doesn’t effects the Hold time or the Hold slack so it is critical to fix the Hold time violations in a design prior to the setup violation if both exists simultaneously

1. it can be better if you will explain by some small circuit design and specified each term from circuit

2. I would say this is one of the best article I’ve read.. From beginning to end you nailed it totally.terminal block connector distributor

3. wonderful Post!! Thanks To Shared With terminal block connector distributor